i change my head gasket, put back every thing in place, but now it will not start. i spray some quick start, it bearly turn over. can someone tell me what to check for to close in on the problem? could it be that it may not be getting gas to the caberator, and how do i check to see if the fuel
pump is working?My 95 oldsmobile cutlass supream will not start.?
check for grounds!!! prolly when u change the gasket .. u forgot to put back a ground!
and.. if u put ethanol and it turn over.. its a injection problem.. check for pulse in the injectors!
good luck!My 95 oldsmobile cutlass supream will not start.?
Re-verify your valve timing..... you may have installed your timing belt a few teeth off. Just be patient and use the process of elimination.... go back over what was messed with and you will find the answer.My 95 oldsmobile cutlass supream will not start.?
Well I don't know how much experience you have doing this but here's some tips. It could be a few things. Start by going over everything you took apart and moved to do the job. Check all those wires, vac-um hoses and such. Make sure they are all put back right and connected properly. Allot of the time in these situations its something dumb you missed and it'll drive you nuts. If you still have a problem check your fuel lines and injectors make sure they are ok and connected right as well as the PLUG WIRES make sure you didn't mix them up. If your unsure about that stuff the internet or a repair manual will have diagrams showing you how it should be. To check the fuel pump make sure its all quiet around the car. Put your key in the ignition and turn the key to the running position WITH OUT starting it and listen for a humming noise from the back of the car it only lasts a second so listen carefully. If you don't hear it then yeah you have a possible problem with it. 95 olds were fuel injected not carbed so you don't need to prime it or spray stuff into it to start, unless somethings wrong with the fuel system it will take care of itself. If you haven't make sure you change your oil and antifreeze to get rid of any contaminants that may of gotten in there before you start driven it. But most likely you missed something or put it back wrong it happens to the best of us. Best of luck.
