Wednesday, November 24, 2010

How to change head gaskets on a 91 camaro 305?

i need to replace the head gaskets on my 91 camaro... i changed the rad. cap and didnt realize it was the wrong one.... i need a site i can go to.. or instructions on how to... i dont know alot about cars.. so kinda detailed instructions... thanks... steveHow to change head gaskets on a 91 camaro 305?
You can go to this site for instructions:



Good Luck



http://www.autozone.com/repair_info.htmHow to change head gaskets on a 91 camaro 305?
buy a chilton or haynes manual at almost any parts store. detailed pics and part by part dissassembly.How to change head gaskets on a 91 camaro 305?
shove it up ur grandma's bunkerHow to change head gaskets on a 91 camaro 305?
I would carry it to a reputable mechanic, because you will probably have to have the heads surfaced before you put them back on. You should also check the heads for warpage and cracks. A mechanic can perform all of this and do it in less time and do it right. Find one that will guarantee his work. Also have the mechanic check your entire cooling system, including the fans.How to change head gaskets on a 91 camaro 305?
305 chevy engines were notorious for cracking the heads so there is a good chance that the heads will be cracked when you get them off. you might not even be able to see the cracks. they crack right next to the intake valve. I would make sure to send the heads and have the magnifluxed before reassembly. also it takes a couple of kind of special tools so it would be best done by a qualified technician.How to change head gaskets on a 91 camaro 305?
its actualy quite simple, first make sure you have good tools and clean work area, start by removing the air cleaner assembly,next remove the gas line and throttle cable, next remove the distributor ther is 1 bolt that holds it down remember to label the wires with the corect , next remove the intake ther should be 6 bolts on each side, next remove the valve covers, unbolt the roccer arms, pill out the push rods MAKE SURE to label them in the EXACT order removed, un bolt the head remove old gasket, install in the revers order, you'll have to keep the valve covers loose as to ajust the rocker arms as needed, you'll also want to time it up. good luck it's quite simple just follow the steps, if you want more detail then buy a haynes or chilton repair manuel, or find a friend that knows how and is willing to help,